I restored my machine for the first time today and it worked flawlessly. However, I noticed something strange during the install...

I built a new machine several months ago and rebuilt windows several times until I figured out how to install it with just the right drivers (minimal install). However, each time I used the same machine name and installed the WHS connector software. Apparently, each time i did this my WHS assigned a new CLSID and now when I try to restore my workstation, I have to check each machine name until I find the one with restore points (the others were all empty).

So, my question is this, how can I clean up these orphaned machine names without impacting the one I am using now so that they don't show up during the restore process? (Is it even possible?) These older machine names don't show up in the console, but obviously the primary one does.