| MediaSmartServer.net http://www.mediasmartserver.net/forums/ |
|
| Can't run ex485 Headless http://www.mediasmartserver.net/forums/viewtopic.php?f=17&t=14223 |
Page 1 of 1 |
| Author: | den [ Wed Nov 11, 2015 1:33 pm ] |
| Post subject: | Can't run ex485 Headless |
So I came across this yesterday. The machine boots up PERFECTLY FINE when either a keyboard or monitor is plugged into the debug board. When trying to boot up with this stuff unplugged it hangs. I decided to plug the monitor and keyboard back in while it's hanging and see the following error message" PXE-E53 No boot filename received". What I've done so far is, enable headless mode and remove the Realtek adapter from the boot order. I reboot headless, it still hangs. Go back into bios and the Realtek adaptor has reappeared in the boot order. I suppose my real question is, how do I permanently remove the Realtek adaptor from the boot order? Keep in mind, with a monitor or keyboard connected via debug board, all is well. This only happens when completely headless. |
|
| Author: | den [ Wed Nov 11, 2015 2:28 pm ] |
| Post subject: | Re: Can't run ex485 Headless |
Oh FFS. This is the 3rd time that I post a problem and it gets fixed immediately afterward. Fixed it completely by accident too. Sigh. |
|
| Author: | Ruben Rocha [ Sat Nov 14, 2015 4:03 pm ] |
| Post subject: | Re: Can't run ex485 Headless |
whatever. Usually it is the j1 jumper missing that inhibits a debug from working at all. |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|